Project Reality Forums

I have been manually entering game.lockfps <value> in console every time i start but this is becoming tedious.

Is there a file I can put this in such as a “config.ini” or a launch option I can add when the game starts?

Thanks

Everytime you start? How come? You should only have to set that once and never again.

He has to do it every time, it's set per game session.

No other input? I read that it was capable for PR before standalone but I haven’t seen anything talking about doing it after that.

Suchar wrote:He has to do it every time, it's set per game session.

For real? mine is locked to like 100 from since i set it like years ago. But I never get constant 100 fps so it didn't really matter.

100 is the default setting...

Suchar wrote:100 is the default setting...

Woopsie then.


Anyways, I'd assume you (TBoy) have a 90hz or 120hz display that would make sense as to why you'd want to go over a 100. Because I'm pretty sure there's no point in going more than 2x your screen's refresh rate.


So I have a suggestion to solve this. Is it possible to have the fps locked by default 60 or 90 frames above the selected monitor's refresh rate.

Coalz101 wrote:Woopsie then.


Anyways, I'd assume you (TBoy) have a 90hz or 120hz display that would make sense as to why you'd want to go over a 100. Because I'm pretty sure there's no point in going more than 2x your screen's refresh rate.


So I have a suggestion to solve this. Is it possible to have the fps locked by default 60 or 90 frames above the selected monitor's refresh rate.

Rendering the game at higher framerate lowers input lag even if the monitor cannot show the higher framerate.